Pulsar KRYPTON - Page 61

Technical inspection
It is recommended to carry out a technical inspection before each use of the device .
Check the following :
The device appearance ( there should be no cracks on the body ).
The state of the objective and eyepiece lenses of the attachment ( there should be no
cracks , grease spots , dirt or other deposits ).
The state of the rechargeable battery ( it should be charged ) and the electric
contacts ( there should be no signs of salts or oxidation ).
The controls should be in working order .
The attachment is properly and firmly fixed on the riflescope .
Technical maintenance and storage
Maintenance should be carried out at least twice a year and include the following steps :
Wipe the exterior metal and plastic surfaces with a cotton cloth to remove dust and
dirt . To avoid damage to the paint coating , do not use chemically active substances ,
solvents , etc .
Clean the electrical contacts of the rechargeable battery on the device using a non -
greasy organic solvent .
Check the eyepiece and the lens and if required remove dust and dirt from the
optics ( preferably using a non - contact method ). Cleaning of the exterior surfaces of
the optics should only be done with products specifically designed for this purpose .
Always store the device in its carrying case in a dry , well - ventilated space . For
prolonged storage , remove the batteries .
Troubleshooting
For technical support please contact support @ pulsar - vision . com .