Pulsar Merger LRF XP50 User Manual


1.
Install the APS 3 battery (11) in the battery compartment (14) of the
device.
2.
Connect the USB Type-C cable (21) to the USB Type-C connector (17)
of the device.
3.
Connect the other end of the USB cable (21) to the Power Adapter (23)
by removing the USB Type-A adapter.
4.
Plug the Power Adapter (23) into a 100-240 V socket.
5.
Wait until the batteries are fully charged (indication in the status bar:
; 1 - built-in battery, 2 - removable battery).
Note: next to the battery compartment (14) on the device body there is a
light-emitting diode (25) to indicate the battery charge level when the
device is switched off.
(25) LED indication Battery status

Pulsar Merger LRF XP50 Specifications

General

Objective Lens Diameter	50 mm
Detection Range	1800 m
Laser Rangefinder	Yes
Wavelength	905 nm
Built-in Memory	16 GB
Wi-Fi	Yes
Stream Vision 2	Yes
Waterproof Level	IPX7
Display Resolution	1024x768
Video / Photo Format	MP4, JPG
External Power Supply	USB-C
Operating Temperature Range	-25 … +50 °C