Pulsar Merger LRF XP50 User Manual

1.
Insert the Battery Pack (11) along the rail into the APS charger (18)
slot as far as it will go. The APS charger is supplied with your device or
purchased separately.
2.
Point A on the battery and point B on the charger should match.
3.
Connect the Micro USB Type-B plug of the USB cable (22) to the port
(19) of the charger (18).
4.
Connect the second plug of the USB cable (22) to the USB port on the
power adapter (23).
5.
Plug the device into a 100-240 V socket.
6.
The LED indicator (20) will display battery charge status.
7.
Wait until the battery is fully charged (LED indication (20): ).
8.
Two batteries* can be charged at the same time: the second slot is
designed for it.
(20) LED Indicator** Battery Charge Status
Battery level is from 0% to
10%. Charger is connected to a
power supply.
Battery level is from 0% to
10%. Charger is not connected
to a power supply.

Pulsar Merger LRF XP50 Specifications

General

Objective Lens Diameter	50 mm
Detection Range	1800 m
Laser Rangefinder	Yes
Wavelength	905 nm
Built-in Memory	16 GB
Wi-Fi	Yes
Stream Vision 2	Yes
Waterproof Level	IPX7
Display Resolution	1024x768
Video / Photo Format	MP4, JPG
External Power Supply	USB-C
Operating Temperature Range	-25 … +50 °C