EasyManuals Logo

Pulsar NX02 User Manual

Pulsar NX02
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
English
button C to engage/disengage the regular alarm/hourly time
signal as desired.
SINGLE-TIME ALARM MODE
[SINGLE-TIME ALARM SETTING]
When button C or D is pressed to set the single-time alarm, the single-time alarm mark
“1-AL” is displayed and the single-time alarm is automatically engaged.
With each press of button C or D, one minute is advanced or moved back, respectively.
If the watch is left untouched in the SINGLE-TIME ALARM mode, it will automatically
return to the TIME/CALENDAR mode in 20 to 30 seconds.
The single-time alarm rings differently from the regular alarm.
ILLUMINATING LIGHT (Electroluminescent panel)
The display remains illuminated if button B is kept pressed.
When button B is pressed in the calendar or blank display of the TIME/CALENDAR
mode, the time/calendar display is shown while the display is illuminated.
The electroluminescent panel loses its luminance as the battery voltage gets lowered.
Also, its luminance level decreases gradually with use.
When the illuminating light becomes dim, replace the battery with a new one. If the light
remains dim after the battery is replaced, have the electroluminescent panel replaced
with a new one by the retailer from whom the watch was purchased. It will be replaced
at cost.
While the illuminating light is used, the watch gives out a slight noise. However, this
is not a malfunction.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pulsar NX02 and is the answer not in the manual?

Pulsar NX02 Specifications

General IconGeneral
BrandPulsar
ModelNX02
CategoryWatch
LanguageEnglish

Related product manuals