Need help?Do you have a question about the Pulsar Z021 and is the answer not in the manual?
Press any button to turn on the illuminating light. Luminance decreases with battery voltage and use.
Turn crown counterclockwise until threads disengage, then pull out.
Push crown back in and turn clockwise until tight to ensure water resistance.
Pull out crown when second hand is at 12, stop second hand, and turn to set time.
Enter setting mode, select items (seconds, hour, minute, etc.) using buttons, and adjust flashing digits.
Toggle alarm and chime on/off using Button A in ALARM setting mode.
Press Button A or B to stop the alarm manually while it is sounding.
Press Button C to enable snooze; alarm stops temporarily and repeats after 5 minutes.
Use Button A to start/stop and Button B to reset the stopwatch up to 23:59:59.
Use Button A to start/stop, Button B to split/release time. Repeat split measurement as needed.
Battery life is approx. 2 years. Uses SEIKO SR626SW (analog) and CR2025 (digital).
Do not remove battery. Keep away from children. Avoid short-circuiting, tampering, or fire.
Batteries are non-rechargeable. Attempting to recharge may cause leakage or damage.
Details water resistance for non-water resistant, 3 bar, 5 bar, and 10/15/20 bar watches.
Optimal performance between 5°C-35°C. Extreme temperatures may cause time loss/gain or battery issues.
Protect watch from strong magnetism, drops, impacts, and exposure to chemicals like solvents.
Recommend checks every 2-3 years. Remove case back protective film before use.
To Next Page
General
