29
English
28
English
REGULAR ALARM MODE
[REGULAR ALARM SETTING]
●
The flashing digits move quickly if button C or D is kept pressed.
●
If the watch is left untouched in the REGULAR ALARM SETTING display with the digits
flashing, it will automatically return to the REGULAR ALARM mode in 1 to 2 minutes.
●
When the 24-hour indication is selected in the TIME/CALENDAR mode, the regular
alarm is also displayed in the 24-hour indication.
●
When setting the hour digits in the 12-hour indication, check that AM/PM is properly set.
SINGLE-TIME ALARM MODE
[SINGLE-TIME ALARM SETTING]
●
The flashing digits move quickly if button C or D is kept pressed.
ILLUMINATING LIGHT (Electroluminescent panel)
●
When button B is pressed in the calendar or blank display of the TIME/CALENDAR
mode, the time/calendar display is shown while the display is illuminated.
●
The electroluminescent panel loses its luminance as the battery voltage gets lowered.
Also, its luminance level decreases gradually with use.
●
When the illuminating light becomes dim, replace the batteries with new ones. If the
light remains dim after the batteries are replaced, have the electroluminescent panel
replaced with a new one by the retailer from whom the watch was purchased. It will
be replaced at cost.
●
While the illuminating light is used, the watch gives out a slight noise. However, this
is not a malfunction.
STOPWATCH MODE
●
Even if the STOPWATCH mode is changed to a different mode while the measurement
is in progress, it continues counting properly. After the stopwatch is used, however, be
sure to stop it as the battery energy is consumed enormously to shorten the battery
life.
●
If the watch is left untouched with the city code flashing, it will automatically return to
the TIME/CALENDAR mode in 1 to 2 minutes.
WORLD TIME FUNCTION
TIMER MODE
[TIMER SETTING]
●
The flashing digits move quickly if button C or D is kept pressed.
●
If the watch is left untouched in the TIMER SETTING display with the digits flashing, it
will automatically return to the TIMER mode in 1 to 2 minutes.
[TIMER OPERATION]
●
Before start using the timer, reset the timer time by pressing button D.
●
Restart and stop of the timer can be repeated by pressing button C.
●
Even if the TIMER mode is changed to a different mode while the measurement is in
progress, it continues counting properly. After the timer is used, however, be sure to
stop it as the battery energy is consumed enormously to shorten the battery life.
To Next Page
Loading...
Need help?
General
