Intelligence Protect Switch
1. When the load reaches the rated power, indicator light turns green.
2. When the load reaches the maximum power, indicator light runs red, the buzzer alarms.
3. When the load exceeds the maximum power for 1 minute, it automatically switches off the output.
4. Press the switch, the generator set works again.
Automatic Generator System (AGS)
After installation, be sure the machine is not overloaded. Once the electricity goes out, the generator
outside circuit, starting and generati
ng automatically. As the outsides
power-supply becomes normal, the
generator will cut off itself and connect the circuit automatically.
will cut off
1. If machine cannot start, please check that whether the indicator glitters when start the machine.
And add oil if it glitters
a) Be sure the load won’t be over loaded, then install the generator;
b) Usually , the AGS switch on the control panel will be on automatic position, and the
key on running position.
2. To put the choke switch on the off position.
Alarm System
1) The indicator light will be on when oil is insufficient and machine starts, the indicator
light will be off when oil is sufficient.
2) When starting the engine, the indicator will be on if the oil is insufficient,
the indicator will be off when
oil is at critical position.
17
To Previous Page
Loading...
Need help?
General