Pulsar PG5250B Owner's Manual

Operation
16
It can be opened and closed by operating the choke lever manually by
choke is used to provide the proper mixture when the engine is cold.
starting.
1. Turn off the switches of the device before connecting to the generator.
2. Start the generator.
3. Insert the plug of the device into the receptacle based on the voltage
requirement of the device.
To stop the engine in an emergency, turn the engine switch "OFF".
4. Push the choke lever to the OPEN position as the engine warms up. The
In order to maintain generator's performance:
Using the Generator Set
Always connect the generator to the ground terminal to prevent
electrical shock.
Add the watt ratings of all the loads that the generator set will be
powering at the same time. Make sure that total wattage will not exceed
the generator rating.
Using DC Output Terminals
You can use 12V 8.3A DC output to charge automotive batteries. Be sure to
monitor the battery charge time.
Over-charge may cause explosion and injury
1. Connect the positive (red) terminal of the battery to the red (positive)
terminal the 12V 8.3A DC Output Terminal on the front panel
2. Connect negative(black) terminal of the battery to the black (negative)
terminal of the 12V 8.3A DC Output terminal on the front panel (DO NOT
REVERSE POLARITY OF CONNECTIONS)
3. Start the generator.

Pulsar PG5250B Specifications

General

Brand	Pulsar
Model	PG5250B
Category	Inverter
Language	English