EasyManua.ls Logo

Pulsar PTG1221S - Page 19

Pulsar PTG1221S
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
OPERATION
Mowing
1. Select your required setting.
2. Start the engine and allow it run, and set it to required speed. See “to start the engine”.
3. Keep a firm grip on the upper handle with engine stop/start lever and drive lever (clutch lever) closed and walk along
with it self-propelling to start mowing.
Working Advices
As soon as grass clippings start to trail the lawn mower, it is time to empty the grass bag.
1. To take off the grass bag, use one hand to lift up ejector flap and the other to grab onto the carry handle. The ejector
flap automatically falls down after removing the grass bag and closes off the rear chute opening.
2. Empty the grass debris in the grass bag, and refit grass Bag.
Always observe the strictest safety procedures when using the lawnmower. Carefully
read the safety instructions of this manual before using the lawnmower.
WARNING!
Never open the ejector flap when the grass bag has been detached (to be emptied) and
the engine is still running. The rotating blade can cause serious injuries!
WARNING!
Before taking off the grass bag, switch off the engine and wait until the blade has
come to a stop.
NOTE!
If any grass residue is caught in the discharge chute, clean it using a brush .Do not
remove grass debris in the mower casing or On the blade by hand or with your feet.
NOTE!
Instead use suitable tools such as a brush or broom. To ensure that the cut grass can be collected into
grass Bag, the discharge opening and inside the mower casing must be cleared of any blockage.

Related product manuals