16
OPERATION
Starting Stopping The Engine
To Start The Engine
As shown in Fig 15-16
1. When starting a cold engine, press down the primer fully 3-5 times.
2. Stand behind the mower. Pull the engine Start/Stop lever toward upper
handle with one hand and place the other hand on the pull start.
3. Pull the pull start out approx. 4-6 inches until you feel a resistance
and then start the engine with a sharp pull.
The blade begins to rotate as soon as
the engine is started.
WARNING!
WARNING! Too much presses on primer
May cause engine flooded When starting
WARNING!
To start the engine, make sure that the spark plug boot is located on the plug and the
machine is filled with sufficient oil and fuel.
NOTE!
Do not operate the machine in enclosed or poorly ventilated areas as the exhaust gas
contains toxic substance. Keep hands, feet, and clothing away from all the moving parts
WARNING!
of the machine. The exhaust and other parts of the machine will become hot during use. Make sure that the
blade is securely fastened before starting the engine.
Primer
a warm engine, the primer does not need to be used. If the
engine stops due to a lack of fuel, refill and press down the
primer 3~5 times.
If the engine fails to start after three pulls,
repeat the process .
NOTE!
!
Fig 15
Fig 16
To Next Page
Loading...
Need help?
General
