Adding / Checking Engine Oil (See fig 5)
•
Place pressure washer on a level surface.
•
•
Carefully add between 500 ml (17oz) of 4-Cycle engine oil (SAE10W30) to empty reservoir until oil reaches
•
Be sure to replace both dipsticks before attempting to start the engine.
•
To check oil, set pressure washer on a level surface, wipe dipstick clean, then reinsert dipstick without re-threading.
FIG 5
Adding Fuel (See fig 6)
•
Set pressure washer on a clean and level surface in an area that is well ventilated.
•
Remove fuel cap.
•
Insert a funnel into the fuel tank and carefully pour gasoline into the tank until fuel level reaches 1.2 inches below the
top of the neck.
FIG 6
15
To Next Page
Loading...
Need help?
General
