2. Service Reminder Reset ( ) :
• ‘Wrench’ symbol glows when ODO meter reading
reached to set Kms.
This icon will glow at-
st nd
1 : 450 Kms 2 : 4450 Kms
rd th
3 : 9450 Kms 4 : 14450Kms
& subsequently at each 5000 Kms.
1. Trip Meter Reset :
• Mode & Set push button is provided for selecting &
resetting ‘ODO/TRIP1/TRIP2’. LHS part of speedo
console.
1.
Press 'Mode' button
for less than 2 sec.
Press 'Mode' button
for more than 15 sec.
Mode changes from
‘ODO/TRIP1/TRIP2’
Selected mode
‘TRIP1/TRIP2’ will get reset.
Other TRIP mode will
continue updating.
2.
Note : Engine & motorcycle speed should be zero.
Speedometer Setting
10
Service Reminder
TRIP1/2
Vehicle speed should always be reduced during extreme road
conditions. The braking distance for motorcycle equipped with an
anti-lock braking system may be longer than for those without it
on rough road conditions. During these conditions the vehicle
should be driven at reduced speeds.
When you apply front brake under conditions which may lock the
wheels, you feel a corresponding sensation (pulsation) in Front
brake lever. This is normal & it means your ABS is active.
Also it is recommended to use both front & rear brakes
simultaneously.
Always slow down when cornering. the anti-lock brake system
cannot prevent accidents resulting from excessive speeds
To Next Page
Loading...
