Pulsar TELOS - Page 67

Wi - Fi is displayed in the status bar as follows :
Indication on the status bar Connection Status
Wi - Fi is switched off
Wi - Fi connection is in progress
Wi - Fi is switched on , no connection with device
Wi - Fi is switched on , device connected
The device is recognized by an external device as TELOS _ XXXX where XXXX are
the four last digits of the serial number .
After entering the password  on a mobile device ( see  Password Setup subsection of
the Wi - Fi Settings section for more information on setting a password ) and setting
up a connection , the icon in the status bar will change to .
.
The Wi - Fi function will turn off automatically if there is not enough battery power for
Wi - Fi . To use the Wi - Fi function again , you need to charge the battery .
Installing the Device on a Tripod
 Screw the tripod adapter  14 ( purchased separately ) onto the tripod mounting plate
until it stops .