10
ANALOGUE TIME SETTING
● When setting the minute hand, first advance it 4 to 5 minute ahead of the desired time
and then turn it back to the exact minute.
● When the crown is pushed in, the minute hand may move slightly. However, this is not
a malfunction.
STOPWATCH
● After the stopwatch has measured 60 minutes, it starts counting again from “00' 00"
oo” as many times as necessary until it is stopped.
● When measuring a long period of time, return the STOPWATCH to the CALENDAR or
TIME display after the stopwatch starts, to prevent any possible mistaken operation.
ALARM
● By pressing button B with the alarm setting function activated, the alarm mark is
displayed and the alarm is automatically engaged.
● When setting the alarm in the 12-hour indication, check that AM/PM is properly set.
Only “P” (PM) is displayed. For the AM setting, there is no indication.
● If the watch is left untouched in the ALARM display or with the digits flashing, it will
automatically return to the CALENDAR display in 1 to 2 minutes.
● Alarm test:
Press and hold buttons A and B at the same time in the TIME or CALENDAR display.
To Next Page
Loading...
Need help?
General
