EasyManua.ls Logo

Pulsar W866 - Pulsar Post-Battery Change Procedures; Pulsar Safety Warnings; Battery Handling Safety

Pulsar W866
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
English
l
Necessary procedure after battery change
After the battery is replaced with a new one or if an abnormal display (broken digits,
etc.) appears, follow the procedure below to reset the IC.
Press and hold buttons A, B, C and E at the same time for more than 3 seconds. The
display will show "TIME" for one second, and then automatically change to the display
of “01.01.17 A 12:00 01".
l
Before using the watch, set the time/calendar and alarm.
WARNING
l
Do not remove the battery from the watch.
l
If it is necessary to take out the battery, keep it out of the reach of children.
If a child swallows it, consult a doctor immediately.
l
Never short-circuit, tamper with or heat the battery, and never expose it to
re. The battery may burst, become very hot or catch re.
CAUTION
l
The battery is not rechargeable. Never attempt to recharge it, as this may
cause battery leakage or damage to the battery.

Related product manuals