English
15
● If CROWN 2 is pulled out to first click within 1 minute after being pushed back in to
normal position, the alarm sounds.
● If CROWN 2 is pulled out to second click, the designated alarm time is canceled with
a warning beep.
* In that case, set ALARM hands to MAIN TIME again, push CROWN 2 back in to normal
position, and then, pull it out to first click and set the desired alarm time again.
However, if CROWN 2 is pushed back in to normal position before the warning beep
stops, the designated alarm time will not be canceled.
STOPWATCH
● If CROWN 1 is pulled out to second click, STOPWATCH hands are reset to “0” position.
● If CROWN 2 is pulled out to first or second click, STOPWATCH hands are reset to “0”
position.
● When stopwatch has been reset and Button A is pressed before the hands reach “0”
position, stopwatch still starts counting when Button A is pressed.
ADJUSTING THE HAND POSITION
● Hands move quickly if the respective buttons are kept pressed.
● After adjusting the hand position, set the main time.
RESETTING THE BUILT-IN IC
● Before using the watch again, be sure to set the main time, adjust the position of
STOPWATCH hands and set the alarm.
To Next Page
Loading...
Need help?
General
