Maintenance
Routine Maintenance - Daily
Wipe down the equipment’s side panels, foot mouldings, console and hand grips everyday using a mild soap solution on a damp cloth. Wipe
Dry with a soft cloth. In addition to this, spray the metal frame (but not the control panel) with a proprietary silicone-based polish and wipe off with a dry
soft cloth.
NOTE: Do not clean the frame with water-based solutions.
Routine Maintenance - Weekly
Thoroughly clean the entire machine using the same cleaning methods as for the Daily Clean. Inspect the frame for rust, bubbling or paint chips.
NOTE: This check is important as perspiration will corrode damaged or unpainted surfaces very quickly. Therefore this maintenance check will help
to maintain the clean and professional appearance of your machines.
Do not clean the frame with water-based solutions.
Routine Maintenance - Quarterly
Because of the amount of pressure which is exerted onto the trainers through heavy exercising, it is possible (although unlikely) for fasteners to
become loose. Therefore it is necessary to do a visual or tool check with the necessary spanners or allen keys that all following nuts and bolts are
Tight; Foot mouldings/Pedal Nuts & Bolts, Handlebar Bolts, Console Bolts, Condition of Handlebars.
This equipment contains hazardous voltages and controls hazardous rotating mechanical parts.
Switch off and disconnect the machine from the mains supply before carrying out any maintenance procedures. (F-T Models only, powered)
NEVER switch on any of the machines while the side panels are removed. (F-T Models only, powered)
ALWAYS replace faulty/damaged parts with new genuine Pulse Fitness parts and never use the Pulse equipment until the machine has been fully repaired.
WARNING
Regularly check the machine for damage, wear, general smooth and safe operation. DO NOT use the machine if any part appears worn, damaged or faulty.
WARNING
10
Technical manual
Assembly manual
Your Console can be updated using the Smart Card slot.
The Smart Card slot can be found at the bottom of the Console.
(See diagram).
The Smart Card will incorporate the new Performance Tracker,
Personal Trainer and Gym Manager Software.
Smart Card
09
Technical manual
Smart Card is to be inserted with
the information chip facing upwards.
To Next Page
Loading...