Pulse 220 - Troubleshooting (Stepper & Cycle); 220 F-ST Pace Stepper; 240;250 F-ST Cycle;Recumbent

Troubleshooting
Control display remains blank
Poor contrast adjustment
Blown fuse in machine.
Control panel failed.
Replace fuse.
Display screen is not clear,
flickers or areas appear faint
Adjust contrast. (Refer to
console user manual)
Heart rate monitor not
working
Monitor strip not fitted
correctly. Failed battery
Adjust position of strip and/or
moisten electrodes. (Refer to
console user manual).
Replace monitor strip.
220F-ST ‘Pace’ Stepper
Fault
Probable Cause
Cure
240/250F-ST ‘Pursuit’ Upright Cycle/’Perform’ Recumbent Cycle
Fault
Probable Cause
Cure
Control display remains blank
Poor contrast adjustment
Blown fuse in machine.
Control panel failed.
Replace fuse.
Display screen is not clear,
flickers or areas appear faint
Adjust contrast. (Refer to
console user manual)
Heart rate monitor not
working
Monitor strip not fitted
correctly. Failed battery
Adjust position of strip and/or
moisten electrodes. (Refer to
console user manual).
Replace monitor strip.
Pedal 'knocking' or uneven
operation when pedaling
Loose crank bolt
Remove plastic cap from
centre of pedal crank and
tighten bolt.
13
Technical manual