Section 7
Initial Menu Settings
While the recorder is stopped, press the Menu button on the front of the recorder and you will enter the Menu selection
screen. Use the
(+ / - )
buttons on the front of the recorder to select the desired menu item.
Initial Menu Settings:
The Power save feature is enabled by default for 1 minute to maximize the battery life between charges. You may choose to
turn off the Power save feature so the recorder is always immediately ready to record. Turning off the Power save feature
may reduce the battery life between charges so you should monitor the battery level until you are familiar with how long
the battery will last between charges with the Power save feature turned off.
To set the Power save feature press the Menu button on the front of the recorder and you will enter the Menu selection
screen. Use the
(+ / - )
buttons on the front of the recorder to select the desired menu item. Scroll down to the Device menu,
press Enter, highlight Power save, press Enter and scroll to the desired Power save setting and press OK. Press the Back
button until you are back at the main screen.
To set the
PUMA 5 mode
you wish to use for recording:
Press the Menu button on the front of the recorder and you will enter the Menu selection screen. Use the
(+ / - )
buttons on the front of the recorder to select the PUMA 5 modes and press the Enter button.
To select the PUMA 5 mode you wish to use for recording, press the
(+/-)
buttons to select the desired mode, Contact,
Tactical or Dictation then push the OK button to select that mode.
------------------------------------------------------------------------------------------------------------
Section 8
Recording and Playback
Contact mode:
RECORDING:
To start a new recording in Contact mode press the REC button on the front of the recorder. The RED LED will turn on and
the recorder will beep once to indicate recording has started. The display screen will also indicate recording has started. The
record icon will turn red, the elapsed time counter will start and the sound level indicators will display the level of the audio. To
Pause a recording in Contact mode press the Pause button on the front of the recorder. The recorder will beep once and the
RED LED on the top of the recorder will blink to indicate PAUSE mode. To resume recording press the REC button on the
front of the recorder. To STOP recording and close the file press the STOP button. The recorder will beep once, the RED
LED will turn off.
Pressing the RECORD HOLD button for 2 seconds while recording locks the recorder in the record mode and disables all
other buttons to prevent accidentally stopping the current recording. A beep tone indicates the RECORD HOLD is active. To
disable the RECORD HOLD mode press the RECORD HOLD button for 2 seconds and the operation of the recorder returns
to normal allowing you to pause or stop the recording. A beep tone signals the RECORD HOLD is disabled.
**Note: The RECORD HOLD function does not affect the power switch on the recorder. Be careful not to accidentally turn off
the recorder while in use.
PLAYBACK:
To playback a recording in Contact mode, stop the recording and use the
(+ / - )
buttons on the front of the recorder to
navigate back to the file you wish to playback then press the PLAY button on the front of the recorder to begin playback.
Press the STOP button on the front of the recorder to stop the playback. To MUTE the audio during playback press the MUTE
button on the front of the recorder. Press the MUTE button again to cancel the MUTE setting. To change the playback speed
press the SPEED button on the front of the recorder. Each press of the SPEED button will cycle through normal, fast and
slow playback speed.
--------------------------------------------------------------------------------------------------------------
To Next Page
Loading...