Puqpress Mini - 5.3 Adjusting the tamping force; 5.4 Selecting the tamping mode; 5.5 Checking the tamping cycle count; 5.6 Checking the cleaning cycle count

15
EN
5. 

5.3 Adjustingthetampingforce


1. upbutton

 downbutton

NOTICE


5.4 Selectingthetampingmode
1. setbutton for 5

 Use the up and downbutton
the setting.
3. 
Mini/Q1
Code Setting Explanation
  

  
tamper base
  
Q2
Code Setting Explanation
  

  
tamper base
  



  Triple tamp
  
4. setbutton
setting.
5.5 Checkingthetampingcyclecount
1. 
and hold the up and downbutton for 3

 


5.6 Checkingthecleaningcyclecount
1. setbutton.
 up and downbutton


3. 


5.7 SwitchingoffthePUQpress
1. 
on/offswitch to O.
 

3. 
