Why is the coffee not leveled after tamping in my Puqpress M2?
If the coffee is not leveled after tamping with your Puqpress Coffee Maker, it could be due to: * Uneven coffee grounds before tamping: Level the ground coffee in the port-a-filter before tamping. * Loose port-a-filter: Re-adjust the lower clamp if the port-a-filter wiggles during tamping.
How to stop ground coffee from sticking to the tamper base of my Puqpress M2 Coffee Maker?
If ground coffee sticks to the tamper base of your Puqpress Coffee Maker, it might be due to: * A greasy or dirty tamper base: Clean the tamper base. * A wet tamper base: Dry the tamper base.
Why does my Puqpress Coffee Maker drive unit make weird noises?
If the drive unit in your Puqpress Coffee Maker is making strange noises, it could be that the drive unit (e-motor and gears) is worn out. Contact the dealer to replace the drive unit and specify the amount of tamping cycles the drive unit has performed. This informs the dealer whether the replacement of the drive unit is covered by the warranty or if the replacement is maintenance.
Essential safety guidelines, warnings, and cautions for safe PUQpress operation.
Provides detailed technical data and model-specific information.
Guide on adjusting the clamp for proper port-a-filter fit and tamping.
Instructions for integrating the PUQpress with a coffee grinder.
Step-by-step guide on operating the PUQpress for tamping coffee.
Instructions on modifying tamping pressure via display and buttons.
General| Type | Automatic Coffee Tamper |
|---|---|
| Model | M2 |
| Tamper Size | 58 mm |
| Tamper Diameter | 58 mm |
| Display | LED |
| Power Supply | AC |
| Material | Aluminum |
| Compatibility | Espresso Machines |
To Next Page
