EN
Add Jongo to your wireless network
The Jongo Setup page should open automatically on
your device. If not, open your internet browser and enter
myjongo in the address bar.
If you want to rename your Jongo, type in the new name
and tap
Change name.
Select your wireless network.
Enter your network password if required and tap Connect.
Once you tap Connect the light will pulse and
then turn solid green to show that your Jongo is
connected.
If the connection fails, the light will flash
red. Don’t worry, this probably means
you mistyped your Wi‑Fi password.
Just go back to step 2 and try again.
If the problem persists visit support.pure.com/us
A
C
D
B
To Next Page
Loading...
