PureLink MAX2 Series User Manual

MAX2 4K60 Cross Platform Matrix Router
41
Install Card as follows.
1. Align the Card with metal guide rail.
2. Gently slide the Card into the frame until it connects to the main frame.
3. Tighten the top and bottom screw knobs (clockwise) to lock the Card to the
main frame.
Removing Card as follows.
1. Disconnect any connected cables.
2. Loosen and pull the top and bottom screw knobs (counterclockwise) to
unlock the Card from the main frame.
3. Gently slide Card out of the main frame
Installing the Matrix Router in a Rack
Note) When mount the Matrix Router in a rack, ensure that none of
the fans have restricted air flow.
Rack Installation Tips
● Write down the serial number (usually located on the bottom of the unit) in an
easily accessible location prior to installing the unit in a rack
● It is recommended to test unit to ensure the unit is working properly prior to
installing the unit in a rack
● It is recommended to use two or more people installing the unit in a rack
● For HDMI Input and/or Output Cards, we recommend using copper cable no
longer than 330ft (10 meters) for HD Video quality assurance. Above 330 ft (10
meters), we recommend using the HDBaseT or Fiber Optic extension system.
This will assure a future with higher resolution Video transmission.
● For HDBaseT Input and/or Output Cards, MAX2 HDBaseT Transceivers are
required.
● For Fiber Input and/or Output Cards, MAX2 Fiber Extenders are required.
MAX2 Fiber Extender Transmitters pair with MAX2 Fiber Input Card and MAX2
Fiber Receivers pair with MAX2 Fiber Output Card.

PureLink MAX2 Series Specifications

General

Brand	PureLink
Model	MAX2 Series
Category	Network Router
Language	English