PureLink MAX2 Series User Manual

MAX2 4K60 Cross Platform Matrix Router
42
● Use crossed RS-232/422 cable for serial control.
● Use crossed RJ-45 cable for LAN control.
Installation and Setup
● Place the Matrix Router into a desired position and screw in the rack ear
holes.
* Recommended to screw all holes for secure installation
● Plug power cord into power supply unit on the Matrix Router. For redundancy
power use, plug power cords into both power supply unit.
● Connect source devices to the Matrix Router's Input Card using appropriate
cables.
● Connect display devices to the Matrix Router's Output Card using appropriate
cables. Connect control devices to the Matrix Router's communication ports.
* Command Protocols are communicated through RS-232/422, LAN, or
front panel touch screen.
● Make sure any connected Extenders' power is on.
* HDBaseT Extenders may not need power if they will be powered via POE
● Turn on the power of display devices.
● Turn on the power of Matrix Router
● Turn on the power of source devices.
Note) For most cases, PureLink's Auto EDID factory default setting
will result in a satisfactory image on the display. It's almost a
plug-n-play system. There may be cases where additional
adjustment is required.

PureLink MAX2 Series Specifications

General

Brand	PureLink
Model	MAX2 Series
Category	Network Router
Language	English