Purell FMX-20 User Manual

PAGE 1 OF 2 0921 IH-9593
H-9593
PURELL HEALTHY SOAP
FMX-20 DISPENSER
1- 80 0 -295- 5510
uline.com
INSTALLATION
1. Open dispenser by
pressing release
button on bottom
and allow front
cover to descend
forward. Use
separate key tab to
unlock cover.
(See Figure 1)
2. Install dispenser
at least 10" above
countertop.
(See Figure 2)
INSTALLING WITH WALL FASTENERS
1. Using back plate as
template, mark and
drill center holes
into wall using 1/4"
spiral masonry drill
bit or 1/4" wood drill
bit (not included).
(See Figure 3)
2. Install #10 x 1"
anchors (not
included) into
drilled holes,
flush against
surface. Insert type
#10 x 1" fasteners
(not included) into
four installation
holes in back plate,
through installation
tape. Tighten
fasteners securely.
Be careful not to
overtighten.
(See Figure 4)
Figure 1
Figure 2
10"
Figure 3
Figure 4
TOOL NEEDED
Countertop
Drill

Purell FMX-20 Specifications

General

Brand	Purell
Model	FMX-20
Category	Dispenser
Language	English

Summary

Installation

Installing with Wall Fasteners

Mount the dispenser using the back plate as a template to mark and drill wall holes.

Installation Continued

Installing with Tape

Clean the surface with alcohol, peel tape, and press firmly for secure adhesion.

Refill Replenishment

Open dispenser, remove empty refill, insert new refill, and close dispenser.