www.PyleUSA.com
6
TWS FUNCTION:
1. Turn on the two identical speakers you want to pair. They must have the same
Bluetooth pairing name and both should be in BT mode. You only need to set
up one of the two units.
2. Press and hold the “PLAY/PAUSE” button for about 4 seconds; the speaker will
make a tone “di” to start pairing and will make the “di” sound three times once
successfully paired.
3. Connect Wireless BT with your mobile phone to play music through the two
paired speakers to create a more powerful surround sound eect.
4. To exit TWS mode, press and hold the “PLAY/PAUSE” button (of the unit that
you set up at the beginning) again to exit the TWS function.
Remark:
In TWS mode, if you connect your mobile phone to the unit (you set up at the
beginning) via the provided audio cable, it will start to play AUX via the TWS
function. In this status, you cannot switch to Wireless BT mode by pressing the
Mode button.
AUX-IN:
For other compatible music devices or your MP3/MP4 players, use the supplied
audio line cable to connect from the device’s “Line Out” to the “Aux In” of this
device. Then, press the “MODE” button; the speaker will prompt “Aux Input Mode,”
then enjoy.
When using an external device, all functions can be controlled by the external
device.
To Next Page
Loading...
