Pyle PCM30A User Manual


Replacement Preset SanDisk Thumb Drive to Restore Music
There is no need to ship back your UMS music player for a replacement unit. Instead, please locate
the enclosed preset SanDisk thumb drive. This will replace your existing SanDisk thumb drive and
restore music at your location.
Locate the UMS music player (Fig 1). This is usually set up in your phone room.
Confirm you have the HP thin client unit with the UMS Logo sticker on the front.
Locate the flash drive on the back of the unit (Fig 2). It will be a small thumb drive (Fig 3).
Step 1. Unplug the power cord from the music player.
Step 2. Remove the SanDisk drive (Fig 2) and discard.
Insert replacement preset SanDisk thumb drive (Fig 3) into the player.
Step 3. Plug in the power cord.
Step 4. Wait 4 minutes for the music unit to boot up and begin playing.
After completion, please call UMS to confirm the music unit is updated.
1-800-373-8200
You have now completed all the steps necessary to restore the music.
Fig1
Fig2
Fig3

Pyle PCM30A Specifications

Input Impedance

AUX input impedance	50k-Ohm
MIC 1/MIC 2 input impedance	600-Ohm
TEL/PAGE input impedance	600-Ohm

Output Specifications

max output power	60 Watts x 1
speaker outputs impedance	4-Ohm, 8-Ohm, 16-Ohm, 25V, and 70V
monitor output impedance	600-Ohm 1V (head phones) and 8-Ohm 1W (speaker)

Power

power requirement	120V AC 60Hz/230V AC 50Hz
power fuse for 110-120V	T 2AL 250V
power fuse for 220-240V	T 1AL 250V

Weight and Dimensions

dimensions	10.7 x 3.46 x 8.86 inches (272 x 88 x 225 mm)
weight	9.79 lbs (4.44 kg)
frequency response	50 Hz to 15 kHz