Pyle PDIC61RD - Installation; Troubleshooting

• If using multiple pairs of main speakers, check if the impedance requirements of
your receiver/amplier are met.
Register Product
Thank you for choosing PyleUSA. By registering your product,
you ensure that you receive the full benets of our exclusive
warranty and personalized customer support.
Complete the form to access expert support and to keep your
PyleUSA purchase in perfect condition.
www.PyleUSA.com
INSTALLATION
The in-wall/in-ceiling speakers were designed to be easily installed. However, if you
are unsure of your ability to properly install these loudspeakers, please contact your
dealer or a qualied installer.
TROUBLESHOOTING
If there is no sound coming from one speaker:
If the system plays at low volumes but shuts o as volume is increased:
• Inspect all wires and connections between the receiver/amplier and speakers,
ensuring proper connection and no damage.
• Verify correct conguration of your receiver/processor, especially in Dolby Digital
or DTS modes, ensuring proper setup of subwoofer output and speaker size settings.
• Consider adding a powered subwoofer to your system for improved bass.
• Ensure correct polarity (+ and -) of connections to the left and right "speaker inputs."
If there is low (or no) bass output:
• Check all wires and connections between the receiver/amplier and speakers for
proper connection and any damage.
• Verify the "Balance" control settings on your receiver/amplier.
• Review the proper operation of your receiver/amplier.
• Inspect all wires and connections between the receiver/amplier and speakers,
ensuring they are properly connected and not damaged.
• Check if the receiver/amplier is powered on and a source is playing.
If there is no sound from any of the speakers:
TOOLS NEEDED
• Pencil
• Phillips #2 screwdriver
• Measuring tape
Model Number:
PDIC61RD
PDIC61RDBK
PDIC61WT
PDIC61RDSL
PyleUSA.com/register
• Utility knife
• Carpenter’s level
• Awl