Pyle PDICBT57 - Page 8

www.PyleUSA.com
8
IF THERE IS LOW (OR NO) BASS OUTPUT:
• Make sure the connections to the left and right “speaker Inputs” have the
correct polarity (+ and -).
• Consider adding a powered subwoofer to your system.
• In Dolby Digital or DTS modes, make sure your receiver/processor is
corectly congured. When using a subwoofer, make sure the subwoofer
output of the receiver/processor has been enabled. If no subwoofer is
being used, make sure the left and right front and rear speakers have
been congured as “LARGE” See your receiver/processor’s owner’s manual
for futher information on correct speaker conguration in Dolby Digital,
DTS and other surround sound modes.
IF THE SYSTEM PLAYS AT LOW VOLUME BUT SHUTS OFF AS VOLUME IS
INCREASED:
• Check all wires and connections between receiver/amplier and
speakers. Make sure all wires are connected. Make sure none of the
speaker wires are frayed, cut, punctured or touching each other.
• If more than one pair of main speakers is being used,check the minimum
-impedance requirements of your receiver/amplier.
PDICBT57 - PDICBT67 - PDICBT87
Wireless BT Streaming Wall / Ceiling Speaker System
MODEL PDICBT57 PDICBT67 PDICBT87
Sound System
5.25’’ Speaker
+ 1’’ Tweeter
6.5’’ Speaker
+ 1’’ Tweeter
8.0’’ Speaker
+ 1’’ Tweeter
MAX Power
Output
240 Watt 300 Watt 400 Watt
Eciency 86dB 88dB 90dB
Frequency
Response
100Hz-20kHz 70Hz-20kHz 50Hz-20kHz
Total Speaker
Size
7.8’’ Diameter,
3.0’’ Depth
9.4’’ Diameter,
3.9’’ Depth
10.7’’ Diameter,
4.6’’ Depth
Cut-Out Size
7.0’’ Diameter,
2.9’’ Depth
7.9’’ Diameter,
3.7’’ Depth
9.6’’ Diameter,
4.4’’ Depth