Need help?Do you have a question about the Pyle PLMRA120 and is the answer not in the manual?
General| Power Output | 120 Watts |
|---|---|
| Channels | 2 |
| Impedance | 4-8 Ohms |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | > 95 dB |
| THD | < 0.1% |
| Input Sensitivity | 200 mV |
Indicator light status when the remote control system is energized.
Connecting to standard car stereo speaker-level outputs.
Adjusting the audio signal level to match output.
Connecting to car stereo or equalizer RCA outputs.
Protects amplifier and electrical system from wrong conditions.
Connection points for +12V DC power supply and ground.
Type of connector for attaching speakers (4 or 8 ohm).
Wiring diagram illustrating RCA input connection from car stereo.
Wiring diagram for connecting speaker-level outputs to the amplifier.
Diagram for connecting power leads, ground, and speakers.
Suggestions for keeping the amplifier dry, clean, and undamaged.
Steps and hardware details for physically installing the unit.
To Next Page
