Need help?Do you have a question about the Pyle PLMRMP1A and is the answer not in the manual?
General| Frequency Response | 20Hz - 20kHz |
|---|---|
| Channels | 2 |
| Signal to Noise Ratio | > 90 dB |
| Input Sensitivity | 200 mV |
| Fuse | 10A |
| Impedance | 4 Ohm |
| Power Supply | DC 12V |
Configure input sensitivity and optimize bass response using polarity switch.
Adjust amplifier gain for balance and use remote volume control for loudness.
Connect audio sources via RCA or Bluetooth, including setup instructions.
To Next Page
