Pyle PMSA20 User Manual

PMSA20
4. Features:
This amplifier is designed to act as a public address
system.
All devices in this series operate on 12V DC.
The speaker outputs are 4-8 ohm low-impedance outputs.
MIC Input 1 has microphone priority override.
5. Precautions & Warnings:
A. Read all documentation before operating the equipment.
Retain all documentation for further references.
B. Avoid storing or using your equipment at a high temperature,
near excessive moisture and/or dust, and near electromagnetic
equipment.
C. Your equipment generates heat during use, so please leave
at least 4 inches of space clear on the sides and 1 inch of
clearance on top.
D. Always operate the equipment with the AC ground wire
connected to the electrical system ground.
E. The AC voltage must be the same as specified on the rear of
the equipment.
F. Please turn off the power switch before pulling out the power
cable.
G. Use a soft, damp cloth to clean your product. Do not use
solvents or cleaning chemicals.

Pyle PMSA20 Specifications

General

Channels	2
Impedance	4-8 Ohms
Frequency Response	20 Hz - 20 kHz
Input Impedance	10 kOhms
Inputs	RCA
Outputs	Speaker Outputs
Signal to Noise Ratio	80 dB

Summary

Features

Precautions and Warnings

Safety and Usage Precautions

Covers documentation, environmental conditions, heat management, grounding, voltage, power handling, and cleaning.

Front Panel Instruction

Front Panel Controls and Indicators

Details the purpose of each button, knob, and indicator on the front panel.

Rear Panel Instruction

Rear Panel Connections

Identifies power input, speaker outputs, and other rear panel connectors.

Power Amplifier Technical Specification