Pyle PTA24BT User Manual

NO POWER
The fuse might be blown
Check the amplier's fuse
and replace it if necessary.
NO SOUND
Sound source or speakers
may not be connected
properly
Check all connections
Master volume control
may be set to a minimum
Adjust the volume control
to a higher setting
The speaker's wire
might have the wrong
impedance
Make sure that the speakers
that you have connected to
the amp are matching in
impedance
The amplier is shutting
down or powering o
Turn the amplier o and let it
cool, make sure that the
amplier is properly ventilated,
and then tum it back on
Feedback
Microphone and speakers
are to close together
Reposition the microphone
and speakers
www.PyleUSA.com www.PyleUSA.com
8 9
MODEL PTA24BT PTA42BT PTA62BT
Total Harmonic
Distortion
1 KHz Rated
Power
0.3% 0.3% 0.3%
AUX 1
AUX 2
AUX IN
MIC
180mV
180mV
200mV
6mV
Input Sensitivity 1 KHz, 4-ohm Rated Power
180mV
180mV
200mV
6mV
180mV
180mV
220mV
6.8mV
Signal to Noise Ratio,1 KHz,4-ohm Rated Power
AUX 1
AUX 2
AUX IN
MIC
81dB
81dB
81dB
68dB
84dB
84dB
84dB
68dB
82dB
82dB
82dB
68dB
BASS 100Hz
±10dB ±10dB ±10dB
TREBLE 10KHz ±10dB ±10dB ±10dB
Frequency
Response,
1KHz 1W,
+/-3dB (8-0HM)
20Hz-20KHz 20Hz-20KHz 20Hz-20KHz
Power
Requirement
120VAC60Hz
or
230V AC 50Hz
120VAC60Hz
or
230V AC 50Hz
120VAC60Hz
or
230V AC 50Hz
Power Output:
250W 500W 750W
SPECIFICATIONSTROUBLESHOOTING:

Pyle PTA24BT Specifications

General

Brand	Pyle
Model	PTA24BT
Category	Amplifier
Language	English