Pyle PTA42BT User Manual

• Let the amplier cool down and see if it starts again before you
assume a fuse needs to be replaced.
• Unplug the amplier from the AC outlet.
• Turn the fuse holder cap and pull out the cap.
• Remove the old fuse and replace it with an identical one.
CAUTION: Never use a fuse with a higher rating
TROUBLESHOOTING
WIRELESS BT STREAMING OPERATION INSTRUCTION:
External devices which have a built-in BT feature can be connected
to this amplier wirelessly to play through the amplier's speakers.
If your amp is connected to speakers, you will hear audible tones
which will help for connecting.
1. At rst be sure that the amplier is powered on, and turn the
volume to low. Please remember to connect the BT Antenna at the
back panel for better receiving signal.
2. Press the BT/Line button switch in on the front panel, you will hear
the voice "POWER ON" and also "PAIRING", and then the unit is
automatically ready to pair with your external device.
3. Turn on the Wireless BT of your external device.
4. Search for available BT devices and make sure to be within range of
your amp, and wait for your device to select "PYLE PRO" on the
pairing devices lists of BT networks.
5. Once connected you will hear a voice say, "Your Device is Connected",
the BT pairing is successful and connected.
6. You can now play music on your external device through the
amplier.
CARING FOR YOUR PYLE AMPLIFIER
Your Pyle Amplier is an example of superior design and craftsmanship.
The following suggestions will help you care for your amplier so
you can enjoy years of use:
• Keep the amplier dry. If it gets wet, wipe immediately.
• Use the amplier only in well-ventilated installations.
• Handle the amplier away from dust and dirt.
• Wipe occasionally with a damp cloth to keep it looking new.
Do not use harsh chemical, solvents or detergents!
IMPORTANT
Replacing a fuse
This amplier requires fuse with the proper
rating for protection from power surges and
short circuits. If the amplier suddenly turns
o or would not turn on, the fuse is properly
blown.
NO POWER
The fuse might be blown
Check the amplier's fuse
and replace it if necessary.
NO SOUND
Sound source or speakers
may not be connected
properly
Check all connections
Master volume control
may be set to a minimum
Adjust the volume control
to a higher setting
The speaker's wire
might have the wrong
impedance
Make sure that the speakers
that you have connected to
the amp are matching in
impedance
The amplier is shutting
down or powering o
Turn the amplier o and let it
cool, make sure that the
amplier is properly ventilated,
and then tum it back on
Feedback
Microphone and speakers
are to close together
Reposition the microphone
and speakers
www.PyleUSA.com6 www.PyleUSA.com 7
This product can expose you to a chemical or group of chemicals, which may include
“Nickel Carbonate” which is known in the state of California to cause cancer, birth defects,
or other reproductive harm. For more info, go to https://www.p65warnings.ca.gov/.

Pyle PTA42BT Specifications

General

Brand	Pyle
Model	PTA42BT
Category	Amplifier
Language	English