12
STORAGE
Store the treadmill in a clean and dry indoor environment. Never leave or use the unit outdoors.
Ensure the master power switch is o and the power cord is un-plugged from wall outlet.
TROUBLESHOOTING GUIDE
LUBRICATION
Lubricating under the running belt will ensure superior performance and extend its life expectancy.
After the rst 25 hours of use (or 2-3 months) apply some lubricant, and repeat for every following 50 hours
of use (or 5-8 months).
How to check running belt for proper lubrication
Lift one side of the running belt and feel the top surface of the running deck.
If the surface is slick to the touch, then no further lubrication is required. If the surface is dry to the touch,
apply some lubricant.
www.PyleUSA.com
Problem Potential Causes Corrections
Treadmill will not
start.
1. Treadmill not plugged in.
2. Safety Tether Key is not
correctly installed.
3. Circuit breaker in the
house has been tripped.
4. Treadmill circuit breaker
has been tripped.
1. Plug the power cord into a wall
outlet.
2. Reinstall the Safety Tether Key.
3. Reset the circuit breaker, or call
an electrician to replace the
circuit breaker.
4. Wait 5 minutes and then try to
restart the treadmill.
Belt slips. Belt not tight enough. Adjust belt tension.
Belt hesitates when
stepped on.
1. Not enough lubrication
applied onto the running
deck.
2. Belt is too tight.
1. Apply lubricant.
2. Adjust belt tension.
Belt is not centred. Running belt tension not even
across the rear roller.
Center the belt.
To Next Page
Loading...
General