8
• SELECT AUDIO MODE
Press SEL button (3) to change audio mode through volume, bass, treble, balance
and fader modes. Use (4) and (5) buttons to adjust the selected mode.
When mode has not been adjusted for 3 seconds, display returns to normal radio
or CD display.
Volume
Adjust volume level by using (4) and (5) buttons.
Note: The unit is initially set to volume mode.
Bass
Press SEL button (3) one time. Adjust bass level by using (4) and (5) buttons.
Treble
Press SEL button (3) two times. Adjust treble level by using (4) and (5) buttons.
Balance
Press SEL button (3) three times. Adjust sound balance between left and right
speakers by using (4) and (5) buttons.
Fader
Press SEL button (3) four times. Adjust sound balance between front and rear
speakers by using (4) and (5) buttons.
• LOUDNESS
Press and release RND/LOU button (11) immediately to reinforce the bass output.
• TIME SETTING
Press DSP button (6) to change the display to clock display, if no key is activated
in 5 seconds, it will automatically return to previous display.
Press and hold the DSP button (6) for 3 seconds until the clock display flashes.
Press (5) to change minutes or (4) to change hours.
• SELECT MODE
During CD operation, press BND button (7) to switch to radio mode. During radio
operation, when a compact disc is inserted in the disc slot, press CD button (12) to
switch to CD mode and start playing.
• LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated functions on the display (17).
• LED
When the front panel does not install on the unit, the LED indicator (18) is flashing.
• RESET
Press RESET button (19) to re-initialized the unit in case abnormalities or malfunction
is observed. When reset is activated, all preset station/program will be cleared.
Reset button can be access by any pointed material.
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
To Next Page
Loading...