8 13
7 LIMITED USER FACILITIES
Six keys on the keypad are marked with symbols. These symbols are shown below
followed by how they will be referred to in the following text.
Shift
Easy-set
Fire
P.A
Up arrow
Down arrow
1) Full Setting the panel
Enter Limited User Code (Factory set to 5 6 7 8)
By using this method, maximum volume will be heard.
or
By using this method, Entry / Exit Tone volume will be reduced.
2) Part setting the panel
The Entry/Exit tone volume will be reduced for any part setting
Part set 1 (e.g. downstairs only armed):
Enter or
Part set 2 (e.g. upstairs only armed):
Enter or
Part set 3 (e.g. whole house armed except garage):
Enter
3) Unsetting the panel
The panel can be unset by entering the building via the entry exit route and then keying
either of the two User codes.
4) Activating the personal Attack Alarm (PA)
To activate the Personal Attack Alarm enter
5) Activating the Fire Alarm
To activate the Fire Alarm
5. Panel Unset / Day mode.
Alarm and Fire Lights flashing,
This event will take place under two
conditions. i.e:
1. If has been entered. (Instant Fire Alarm)
2. If any smoke detectors, connected to the
system, have been triggered.
To stop audible alarm and clear LEDs :
Enter or
Master User code Limited User Code
8. Panel unset / Day mode.
Fault and Day lights are on, indicating that a
mains failure has taken place.
Check tahat there is mains power elsewhere on
the premises.
If not, wait for mains power to return.
If there is mains power, contact your installation
company.
8
6. Panel unset / Day mode
Alarm and Tamper lights flashing, indicating
that a Tamper alarm has taken place.
To stop audible alarm and clear LEDs :
Enter or
Master User code Limited User Code
Now try setting the system.
If the system goes straight into an alarm
condition contact your installation company.
7. Panel unset / Day mode.
Fault light flashing, indicating that the panel
is in Engineer's Mode.
To exit Engineer's Mode,
Enter
RDOC147Jissue3
Engineer code
To Next Page
Loading...
