What does 'WLs TAMPER Bxx' mean on my Pyronix Security System?
The 'WLs TAMPER Bxx' message on your Pyronix Security System indicates that you should check the tamper switch on the mentioned radio bell.
How to fix 'BATTERY FAULT xxx' on Pyronix PCX 78?
The 'BATTERY FAULT xxx' indication on your Pyronix Security System is normal during recharge after a mains failure.
What does 'LOW VOLTS xxx' mean on my Pyronix PCX 78 Security System?
The 'LOW VOLTS xxx' message on your Pyronix Security System indicates that the voltage coming out of the control panel PSU is not at the required ~12VDC. Ensure that the voltage is at this level.
What to do if my Pyronix PCX 78 shows 'CASE TAMPER'?
If your Pyronix Security System shows 'CASE TAMPER', ensure the tamper switch is closed.
What does 'WLs JAMMING Pnl' mean on my Pyronix PCX 78 Security System?
The 'WLs JAMMING Pnl' message on your Pyronix Security System means that you should check that no radio interference is in close proximity to the radio devices or the panel.
What to do if there is an 'Alarm during the arming procedure' on my Pyronix PCX 78 Security System?
If there is an 'Alarm during the arming procedure' on your Pyronix Security System, do not activate instant Inputs during the arming procedure.
What does 'Error Area not accessible' mean on my Pyronix PCX 78 Security System?
The 'Error Area not accessible' message on your Pyronix Security System means it would be impossible to fully disarm the system after a tamper alarm on that Input. Programming must be adjusted before exiting Engineer mode.
What does 'Error some Areas cannot be disarmed' mean on my Pyronix Security System?
The 'Error some Areas cannot be disarmed' message on your Pyronix Security System means that programming must be adjusted before exiting Engineer mode.
What to do if my Pyronix Security System shows 'DIGI Call Fail 100'?
If your Pyronix Security System displays 'DIGI Call Fail 100', check that all communication devices on the panel have a valid signal.
How to fix a blank keypad display on my Pyronix PCX 78 Security System?
If your Keypad display is blank: 1. Check the keypad address by pressing and holding 'd' until the security code is required. 2. Enter 2000 and set the keypad address. The primary keypad address MUST always be set to [00]. 3. Make sure in the Install Keypads and Readers menu in Engineer mode that the keypad address is set up correctly.
Overview of the PCX hybrid alarm system.
Key considerations for safe and compliant wiring practices.
Accessing and navigating the primary programming menu.
Identifying and understanding device failure messages.
Troubleshooting common system faults and communication issues.
General| Wired zones | 8 |
|---|---|
| Partitions | 4 |
| Weight | 2.5kg |
| Type | Hybrid Alarm Control Panel |
| Wireless zones | 70 |
| Inputs | 8 |
| Operating Temperature | -10°C to +50°C |
To Next Page