What to do if Q-See Network Hardware remote control does not work?
If the remote control for your Q-See Network Hardware isn't working, it may be necessary to enter the correct Device ID on the remote control. Also, the distance may be too far, or the control angle too wide. The remote control battery power could also be low, or the remote control or NVR front panel might be damaged.
Why is there only mosaic, no video when previewing or playing back video file remotely on Q-See QC818?
If you're seeing only mosaic and no video when previewing or playing back video files remotely on your Q-See Network Hardware, it could be because the network bandwidth is insufficient. Another reason could be that the computer doesn't have enough resources to handle the video flow. This mode can result in mosaic if there is multiple-cast group setup in combo NVR. There might also be a privacy mask or channel protection setup, the current user doesn't have monitoring rights, or the NVR local video output quality is not good.
General| Channels | 8 |
|---|---|
| HDD Bays | 1 |
| Max HDD Capacity | 6TB |
| USB Ports | 2 x USB 2.0 |
| Video Compression | H.264 |
| Network Interface | RJ45 |
| HDMI Output | Yes |
| VGA Output | Yes |
| Power Supply | 12V DC |
| Operating Temperature | 14°F – 131°F (-10°C – 55°C) |
Details the product's technical capabilities and design.
Explains how to connect the NVR and its components.
Covers the fundamental steps for using the NVR system.
Introduces the main menu structure and available submenus.
Guides on how to physically connect PTZ cameras to the NVR.
Details how to connect external alarm devices to the NVR.
Instructions for installing or replacing the NVR's hard disk drive.
Provides solutions for common NVR operational problems.
Lists conditions not covered by the product warranty.
To Next Page
