10
Grounding Instructions
This product must be grounded. In the event
of an electrical short circuit, grounding
reduces the risk of electric shock by
providing an escape wire for the electric
current. This product is equipped with a
cord having a grounding wire with an
appropriate grounding plug. The plug must
be plugged into an outlet that is properly
installed and grounded in accordance with
all local codes and ordinances.
WARNING - Improper installation of the
grounding plug can result in a risk of electric
shock.
If repair or replacement of the cord or plug
is necessary, do not connect the green
grounding wire to either at blade terminal.
The wire with insulation having a green outer
surface with or without yellow stripes is the
grounding wire and must be connected to
the grounding pin. Check with a qualified
electrician or serviceman if the grounding
instructions are not completely understood,
or if you are in doubt as to whether the
product is properly grounded. Do not
modify the plug provided. If the plug will
not fit the outlet, have the proper outlet
installed by a qualied electrician.
IMPORTANT: use only a 3-wire extension
cord that has a 3-blade grounding plug
and a 3-slot receptacle that will accept
the plug on the product. Make sure your
extension cord is in good condition. When
using an extension cord, be sure to use one
heavy enough to carry the current your
product will draw. an undersized cord will
cause a drop in line voltage resulting in loss
of power and overheating. a 12 gauge
cord is recommended. If an extension cord
is to be used outdoors, it must be marked
with the suffix W-A after the cord type
designation. For example, a designation of
SJTW-A would indicate that the cord would
be appropriate for outdoor use.
OPERATION
Before beginning always check and tighten
all ttings securely.
WARNING: A loose connection could burst
loose under pressure causing a hazardous
condition. Ensure that all connections are
tight. This includes both ends of the hose, the
gun lter, the tip guard, the pump lter, and
the suction tube gland nut
WARNING:Always ensure that the gun safety
latch is in the locked position.
The gun safety latch should always be set.
The only time the trigger should be unlocked
is when the gun is actually being triggered.
Leave the tip out of the gun when priming,
ushing and cleaning.
Gun Trigger
Gun safety latch
Lock
Unlock
To Next Page
Loading...
Need help?
General
