HSC505-E 8-32 Zone LCD Home Security Controller - User Manual
________________________________________________________________________________________________
Page 6
This document and product are copyrighted and all rights are reserved.
Enter 4-digit pin number _______________ or the bypass key to delete an existing user.
Keypad displays “Authority part 01”.
Enter desired user authority:
00 root - allows all access functions to all authorized partitions and programming of all user levels.
01 super user - allows all functions including changing of user codes level 2 and downwards in
authorized partitions.
02 master user - allows all access functions and user programming in its allocated partition only.
03 normal user - allows all access functions but no user programming in its authorized partition only.
04 arm/disarm - bypass only.
05 duress user - arms and disarms with normal indications but communicates a silent duress/panic
signal to the monitoring center.
06 arm only - user allows arming of the system only.
07 control code - assignable to a trigger output only, which is recorded in the historic log used as
access control, etc.
08 disabled - no user functions.
Press # key.
Keypad displays “authority part 02”.
Enter desired authority level for part 2.
Press # key.
Repeat for partitions 3 and 4.
Keypad displays “Prog “ to save.
Press “Prog" key to save the user setup.
System returns to “Next user”.
Repeat for all additional users to be entered into the system.
Press “Home“ to exit user programming.
Display zone descriptors:
Enter user programming mode.
Select 1.
Press # to accept.
Keypad displays “Display zone dir “ “Select 01 to 32”.
Enter zone number to view.
Press # to accept.
Keypad displays that zones details, including chime status, then scrolls through the remaining zone
details in the partition.
To exit this mode press ”Home” key.
Enable or disable chime:
Enter user programming.
Select 2.
Press # to accept.
Keypad displays “Set chime” “1 = on 2 = off”.
Make selection as required.
Keypad displays “Enabled” or “Disabled”.
To exit this mode, press the “Home” key.
Keypad returns to normal operation.
Edit chime zones:
Enter user programming.
Select 3.
Press # to accept.
Keypad displays “Z01 chime “on” or “off”.
Press key 1 to enable or key 2 to disable.
Press “Instant” key for next zone.
To exit this function, press the ”Home” key.
To Next Page
Loading...