12
Extend the spindles until the Wall Cups stick to the
surface (if you are using QRF Spindles™ over a quarter
round, make sure the QRF
Spindle™ head is pointing
upward inside the Wall
Cup).
Push spindles back into
gate (leaving Wall Cups
sticking to wall) and
temporarily remove the gate.
We strongly recommend attaching Wall Cups with the
included Wall Cup screws. If screwing into drywall,
carefully screw them all the way in without over-
tightening. The adhesive holds the Wall Cup to the wall
and the function of the screw is to prevent sideways
movement. Surfaces that are not acceptable for adhesive
only – wallpaper, uneven surfaces, surfaces with flaking
paint, or oily surfaces. If you are uncertain, it’s always
better to be safe rather than sorry, so we strongly
recommend that you use the Wall Cup screws.
Step 8
Reposition the gate centered in the opening and then
by hand start tightening lightly the hand wheels on the
Top Spindles and nuts on the Bottom Spindles until the
spindle heads nest inside
the Wall Cups.
Next using the Installation
Wrench, tighten the nuts
on the bottom spindles.
Alternate between the sides
until the red area inside
To Next Page
Loading...
