QIDI X-MAX 3 - Page 9

14
Load
the
into the extruder, click
below button for
loading filatnent untill
filatnont come out
from nozzle,
Click the downwards button and allow the filament to emerge from the nozzle.
Notice: If there is no filament flowt even after multiple attemptst check that the filament is properly
entering the printhead.
Load (3/3)
Enswe the filament
into the extruder, click
below button for
loading filament untill
frlannont come out
from
Click "Next" and finish the start guide.
Guide tutorial
finis •d
Ploaso IZIdorm auto bod tovolir.g and
input shaping befc«e printing.