Remote control
The remote control sends signals to the system.
SLEEP button
To set or deactivate the SLEEP mode
MODE button
To select the operating mode:
Feel, Cooling, Dry, Fan and Heating
DOWN button (TOO HOT button)
To decrease the set room temperature
and reduce the time.
UP button (TOO COLD button)
To increase the set room temperature
and lengthen the time.
FAN SPEED control button
To select the fan speed of the indoor unit:
automatic, high, medium and low.
control button (horizontal blade)
To set the direction of the air flow.
ON/OFF button
To turn on or off.
Operate both Mode and Timer to Lock/
Unlock the buttons
Turn on/ off the indoor display
Sensing the temperature around the remote
controller to control the unit
Turbo mode. Enable the unit to reach the
preset temperature in short time
Mute mode. To run in a silent and
comfortable mode
Starts or stops energy efficient
saving features
TIMER button
To select the TIMER function.
Note: Every mode and the relevant functions will be specified hereafter.
Placement of batteries
Remove the battery cover in the direction of the arrow.
Insert new batteries as shown (align the positive (+) and negative (-) symbols.
Slide the battery cover back in position.
Note: use 2 LR03 AAA(1.5volt) batteries. Do not use rechargeable batteries. Replace batteries with batteries
of the same type (see above) if the display becomes more blurred.
Storage of the remote control and tips for using
The remote control can be stored in a holder, mounted against the wall.
Using the remote control
Point the remote control towards the receiver on the indoor unit of the air conditioner. This way, the air
conditioner can be operated from a distance up to 7 meter.
45
4
To Next Page
Loading...
Need help?
General
