QNAP TS-1673U User Manual

• TS-1673U, TS-1673U-RP
1. Insert the tray into the drive bay.
2. Push the handle.
3. Slide the lock to the right.
5. Power on the NAS.
Installing M.2 Solid State Drives
The TS-x73U NAS has two M.2 SATA 6Gbps SSD slots. For a list of compatible M.2 SSDs, go to http://
www.qnap.com/compatibility.
Warning
• Only qualified personnel should perform the following steps. Failure to follow
instructions can result in serious injury or death.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
Note
QNAP recommends installing heatsinks on the M.2 SSD controllers to enhance cooling
efficiency and to ensure consistent performance.
1. Power off the NAS.
2. Disconnect the power cord from the electrical outlet.
3. Disconnect all cables and external attachments.
4. Remove the top cover.
a. Loosen the screws on the back of the cover.
TS-x73U User Guide
Installation and Configuration 22

QNAP TS-1673U Specifications

General

Brand	QNAP
Model	TS-1673U
Category	Storage
Language	English