Note
This image shows the TS-664 connected to two TR-004U USB expansion units.
3. Power on the expansion units.
4. Power on the NAS.
5. Verify that the expansion units are recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
Connecting SATA Expansion Units
The NAS supports connecting one SATA expansion unit. For required accessories details, see Expansion Unit
Installation
1. Power o the NAS.
2. Install a host bus adapter on the PCIe slot.
For details, see Installing Expansion Cards
Note
The QNAP QXP host bus adapter is required for connecting the SATA JBOD enclosure to a host
device. Third-party host bus adapters are not compatible with QNAP JBOD enclosures.
3. Connect the expansion unit to the NAS using the following topology.
TS-x62, TS-x64 User Guide
Installation and Conguration 46
To Next Page
Loading...
Need help?
General
