32
High voltage is present in the cable and will pose a shock hazard. Do not touch the
converter assembly until the power switch is off and the unit is unplugged.
Should the Sonicator display an Error screen, follow the directions on the screen to remedy
the fault. See Section 11, Troubleshooting for additional information.
In general use, the cable assembly should not be used to carry the converter or pull it toward
the user. Make certain the cable always has slack and is never tensioned. If necessary,
move the generator or converter assembly closer to one another to accomplish this. If this is
not possible, contact QSonica to obtain a longer cable.
Should the Sonicator stop functioning, shut the unit off and inspect the cable as above before
any other action is taken.
Recommended cleaning steps:
Removing stud from horn
Clean threading inside of horn
To Next Page
Loading...
Need help?
General
