Rev. 3-11
17
REVIEW: The REVIEW function provides a “window” on the process by displaying various
operating parameters without process interruption. Pressing the ENTER/REVIEW key
repeatedly during processing will consecutively display the following information.
a) Selected amplitude:
e.g. Amplitude 40%
b) Selected processing time and elapsed processing time:
e.g. Set 0:30:00 Time 0:22:10
c) Selected pulsing cycle and actual pulsing cycle:
e.g. Pulse 01 01 / 01 00
d) Amount of power in watts, and accumulated amount of energy in JOULES delivered
to the probe (Note: The amount of energy displayed will be only for one cycle.
Initiating a new cycle will reset the display to zero.):
e.g. 20 watts 0000000 Joules
e) Elapsed time since processing was initiated:
e.g. Elapsed time 0:44:20
Refer to Section 9 if an overload condition exists.
To Next Page
Loading...
