76
Customer Helpline 0845 034 2279
www.gardenservicecentre.co.uk
Customer Helpline 0845 034 2279
www.gardenservicecentre.co.uk
Step 2
Assembly
1. Hold the top and bottom clamp snugly in position on the shaft so that the handle will be located
to the operators’ left.
2. Insert the end of the handle between the clamps. Align the bolt holes and push the long bolt
through the handle side.
3. Place short bolt through opposite side of clamp. Install at washer, lock washers and hex nuts to
hold the assembly in place.
4. After assembly is complete, adjust the position of the handle for best balance and comfort.
5. Tighten the long bolt rst and then the short bolt.
Step 3
Attach the curved shaft grass guard by snapping the guard around the shaft so it locates with the
bracket. Fix in place by inserting the bolts through the guard and bracket and tighten up.
Assembly
STOP!
Do not start the engine before reading page 7-9 of the Operation and Maintenance Manual.
Customer Helpline 0845 034 2279
Our dedicated UK based customer helpline is open 7 days a week to assist you with assembly,
parts queries and technical support. We are open during ofce hours but you can always send an
email via support@gardenservicecentre.co.uk. Our experts are here to get you back enjoying
your garden in no time.
For useful assembly, starting and maintenance videos and ordering spares please visit
www.gardenservicecentre.co.uk.
Calling our service does not affect your statutory rights
UK/Ireland 0845 034 2779
Monday to Friday 9am – 5pm Saturday & Sunday 11am – 4pm
www.gardenservicecentre.co.uk
email: support@gardenservicecentre.co.uk
Getting Help
To Next Page
Loading...
Need help?
General
