Quantum DXi V1000

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
108 CLI Error Codes
E1501 Program aborted by delayed interrupt signal
E1502 Program aborted by segmentation fault (SIGSEGV)!
E1503 Failed to spawn child process
E1600 Section is not found.
E1601 Key is not found.
E1602 Parameter not found.
E1603 Parameter not found in the specified section.
E1604 Value is not found.
E1605 Key value pair is not found.
E2000 This command requires admin privilege to run.
E2001 This command requires monitoring privilege to run.
E3001 Locking: null pointer
E3002 Locking: invalid openfile type
E3003 Locking: invalid parameter
E3004 Locking: memory allocation failed
E3005 Locking: failed to open lock file
E3006 Locking: failed to close lock file
E3007 Locking: failed to set lock
E3008 Locking: failed to get lock info
E3009 Locking: failed to unlock file
E3010 Locking failed because file was locked by another process!
Try again later.
E3011 Locking: dead lock
E3012 Locking: resource is not locked!
E3013 Locking: resource filename is invalid!
E3014 Locking: resource filename is a NULL pointer!
E3015 Locking: resource filename is missing (empty)!
E3030 Locking: no mapping from locking library error to sys error!
E3101 Decryption: source string is not encrypted.
E4000 syscli has no option.
E4001 Option --debuglevel has invalid value!
E4002 Option --sleepatleast has invalid value!
Error Code Error Message